Thursday, February 5, 2015

Approximate Electrical Load Ratings-Entegra Coach


APPROXIMATE ELECTRICAL LOAD RATINGS

12 Volt System

Aisle Lights 1.0 AMP

Baggage Compartment Lights 1.4 AMPS

Decorative Wall Lights 1.5 AMPS

Dinette Light 4.5 AMPS

Exterior Entertainment Center 5-7 AMPS

Fantastic Fan 1.5 AMPS

Fluorescent Double Lights -12” 2.0 AMPS

Fluorescent Double Lights -18” 2.5 AMPS

Furnace 12.0 AMPS

Generator Start 95.0 AMPS*

Halogen Light 1.7 AMPS

Illuminated Switch .125 AMP

Inverter variable

Leveling System 95.0 AMPS*

LP Detector .125 AMP

Map Light 1.5 AMPS

Porch Light 1.5 AMPS

Power Awning 10.0 AMPS

Power Vent 5.0 AMPS

Refrigerator 3.0 AMPS

Shower Light 1.4 AMPS

Step Cover 10.0 AMPS

TV Plate/Antenna Booster 1.0 AMP

Vanity Light 4.2 AMPS

Water Heater 6.0 AMPS

Water Pump 7.0 AMPS

*Momentary Load

12 Volts: Labeled watts divided by 12 = Power consumed in AMPS

 

120 Volt System

Air Conditioner 18 AMPS

Coffee Maker 6-12 AMPS

Converter (each) 8 AMPS

DVD System 3 AMPS

Hair Dryer or Curling Iron 10-14 AMPS

Microwave 12 AMPS

Refrigerator 6 AMPS

Satellite Receiver 2 AMPS

TV 2-4 AMPS

Vacuum Cleaner 8 AMPS

Washer/Dryer 12 AMPS

Water Heater 12 AMPS

120 Volts: Labeled watts divided by 120 = Power consumed in AMPS
 
 
Guidelines
When connecting appliances to the electrical system, remember that 120-volt
power usage is limited to 50 amps per electrical system leg for a total of 100
amps. Be mindful of the fact that each operating appliance collectively places an
added load on your 120-volt electrical system.
 
An unintentional “trip” of a circuit breaker may occur if you overload the motor
home’s and/or campground’s electrical system. The amperage rating of individual
appliances can be calculated by dividing appliance wattage consumed (normally
listed on the appliance) by nominal design voltage (120 for a 120-volt appliance).
For example: 1200 watts divided by 120-volts equals 10 amps.
 
Only connect the shore power cord to RV 50 amp 120/240 volt electrical
power receptacles.
Do not connect the 120-volt 50 amp shore power cord to any power
receptacle until you have contacted the campground owner and/or
premise attendant to verify proper shore receptacle polarity and
grounding. Polarity indicators can be purchased in most electrical and
hardware stores.
Do not use a cheater plug, adapter or extension cord to reduce incoming
AC power or to break the continuity of the power cord grounding circuit.
Do not connect the power cord to an outlet that is not grounded or adapt
the 50 amp power cord plug to connect to a receptacle for which it is not
designed.
Do not remove the power cord grounding terminal to allow connection with
a non-grounded receptacle. Disabling the grounding circuit of the shore
power cord may create a shock or electrocution hazard.
Do not connect the power cord to an extension cord. Use of an extension
cord can cause overheating of the extension cord and can create a low
voltage condition. Premature failure of connected 120-volt AC powered
equipment may result.
 
It is the responsibility of the owner to ensure that the electrical receptacle being
used is properly wired and grounded.
 
Reverse polarity and/or improper grounding of the motor home can cause property
damage, personal injury or death. Failures due to improperly wired and grounded
electric receptacles are not covered by the limited warranty.
 
 
 
Darren Williams
 
 
 

No comments:

Post a Comment